Hit-products LogicPLUS S 42/128 Instrukcja Użytkownika Pobierz pdf (Strona 8)

LogicPLUS-S Two-Wire Controller



Mounting the controller...........When selecting the controller installation location, 





 When mounting the LogicPLUS-S indoors, notice the “keyhole” shaped mounting slot

as well as 2 mounting holes on the back of the controller. Use the template provided to locate mount-

ing screw locations. Remove the four face plate screws and two lower panel screws to access enclo-

sure mounting screws. To attach to wall studs, use a #10 screw, leaving 1/4” of the shank exposed to

slip into the “keyhole” slot. To additionally secure the controller, drive additional screws through the

bottom mounting holes into the stud or cross bracing.

 use the same procedure as above. When attaching

the controller to hollow walls, masonry, or cinder blocks, use appropriate toggle bolts, masonry shields

or compression drive bolts. For additional weatherproong, run a silicon bead around the case be-

tween the controller and the wall. It is also recommended to ll mounting holes with silicon as well, to

prevent water or insects from entering the controller.



             











Unscrew the LogicPLUS-S bottom terminal plate and route the eld wires (one to four sets) through

the hole at the bottom of the controller. Secure each 2-wire run under the appropriate terminal on the

terminal strip labeled     If using multiple outputs, keep each 2

wire set independent.  “Line 1” with output   with  or any

other combination. It is strongly suggested to use different colored wires for each wire used.





To easily test for communication and wire integrity, connect each receiver to the eld wiring at each

planned location. It is not necessary for receiver to be attached to solenoid/valve for test, but O.K. if

already connected. Do not allow black receiver wires to touch each other (short or ground) when test-

ing. Manually sequence controller through each station number for minimum of 30 seconds, checking

each activated receiver in the eld for a continuously activated bright LED light on each receiver. A

continuously activated bright LED light on receiver during station activation conrms satisfactory com-

munication.

Please read the entire operational manual before installing and programming the LogicPLUS-S

Controller.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 44 45

Brak uwag

Hit-products LogicPLUS S 42/128 Instrukcja Użytkownika Strona 8